UF Membrane Module 6 inch PVC Ultrafiltration Membrane Module UFc160AL Well Water Treatment

Short Description:

● Clamps added to end caps make better pressure endurance (>1MPa), effectively prevent UF systems from cracking and leaking due to instant high pressure and impact;

● Unique central tube water distributing process makes water distribution evenly;

● UPVC housing has good aging resistance, acid & alkaline resistance, which is applicable to a wide range of operating conditions;

● Anti-degumming structure makes epoxy resin and end cap an entirety, ensuring adhesion and tightness;

Send email to us

Product Detail

Product Tags

Product Overview

UFc160AL capillary hollow fiber membrane is high polymer material, which will not have any phase change. Modified PVC material, which is adopted on this product, has good permeable rate, good mechanical properties, good chemical resistance and pollution resistance. MWCO is 100K Dalton, membrane ID/OD is 1.0mm/1.8mm, filtering type is inside-out.

Applications

Production of mineral water, spring water, or other sterile liquid.
Drinking treatment of tap water, surface water, well water and river water.
Pretreatment of RO.
Treatment, recycle and reuse of industrial waste water.

Filtration Performance

This product is proven to have below filtering effects according to the service conditions of different water sources:

Ingredient	Effect
SS, Particles > 1μm	Removal Rate ≥ 99%
SDI	≤ 3
Bacteria, Viruses	> 4 log
Turbidity	<0. 1NTU
TOC	Removal Rate: 0-25%

*Above data is obtained under the condition that feeding water turbidity is < 15NTU. This product is qualified for drinking water related products

Product Parameters

product-description14

Technical Parameters:

Filtering Type	inside-out
Membrane Material	Modified PVC
MWCO	100K Dalton
Membrane Area	16m²
Membrane ID/OD	1.0mm/1.8mm
Dimensions	Φ160mm*1415mm
Connector Size	DN32

Application Data:

Pure Water Flux	4,700L/H (0.15MPa, 25℃)
Designed Flux	35-100L/m².hr (0.15MPa, 25℃)
Suggested Working Pressure	≤ 0.2MPa
Maximum Transmembrane Pressure	0.2MPa
Maximum Working Temperature	45℃
PH Range	Working: 4-10; Washing: 2-12
Operating Mode	Cross-flow or Dead-end

Feeding Water Requirements:
Before feeding water, a security filter < 50 μm should be set to prevent blockage caused by large particles in raw water.

Turbidity	≤ 15NTU
Oil & Grease	≤ 2mg/L
SS	≤ 20mg/L
Total Iron	≤ 1mg/L
Continuous Residual Chlorine	≤ 5ppm
COD	Suggested ≤ 500mg/L

*Material of UF membrane is polymer organic plastic, there must not be any organic solvents in raw water.

Operating Parameters:

Maximum Backwashing Pressure	0.2MPa
Backwashing Flow Rate	100-150L/m².hr
Backwashing Frequency	Every 30-60min.
Backwashing Duration	30-60s
CEB Frequency	0-4 times per day
CEB Duration	5-10min.
CIP Frequency	Every 1-3 months
Washing Chemicals:
Sterilization	15ppm Sodium Hypochlorite
Organic Pollution Washing	0.2% Sodium Hypochlorite + 0.1% Sodium Hydroxide
Inorganic Pollution Washing	1-2% Citric Acid/0.2% Hydrochloric Acid